Wyze Meet Any On Bed Part II

thingiverse

I just learned this crucial tip - don't use ABS with printing. V3 added a hollow base, which makes it stronger and more efficient. V2 is an upgraded version with a thickness of 5mm compared to the initial 3mm. I would recommend using V2 over V1 because it's not thick enough. I created this bracket as a replacement for the existing Remix model: https://www.thingiverse.com/thing:3495817 This design has several advantages - it's more straightforward to print, and you can print each part separately. I personally use PETG, but PLA might not be strong enough. When attaching the WyzeCam, pay close attention to the soft pad underneath the base. To secure it in place, gently squeeze these pads until they're firmly attached.