Wyze Gopro Mount

thingiverse

REVISION: It's been noted that my nut pockets are oversized. The nut is spinning freely within the hex-shaped pocket. To address this, I've revised and downscaled the nut pocket to accommodate a 5mm nut with precision. This adjustment pairs well with an 8mm shaft and flats, particularly suitable for 02 and 03 R1 models. I designed this mount specifically for my Wyze camera, combining it seamlessly with a Gopro setup. To integrate this mount, you'll need to remove the small legs attached to the camera. Begin by removing one long screw and its corresponding nut, carefully saving both components as they will be reused. Next, detach the leg from the camera. Then, replace it with the new leg and reattach the screw and nut in their original position. On my particular camera model, the small nut features a protruding round part within its hexagonal shape. I've pointed this out to ensure that the flat surface of the nut securely grips the pocket. To complete the installation, attach the mount in an inverted orientation compared to its original placement. This custom mount is printed using ABS with a 0.2mm layer thickness and 50% infill density.