WYZE Contact Sensor Switch Holder

thingiverse

Two Part Pegboard Mount for WYZE Contact Sensor Switch Holder The two components are designed to pegboard mount Drew Calder's Switch Bracket for Wyze Sense (https://www.thingiverse.com/thing:4290143). The .STL was chopped and a slide in base added to mate with a companion pegboard bracket. This bracket can also be used to mount a WYZE Cam V2 (https://www.thingiverse.com/thing:4335549). Unfortunately, when looking at ways to remix this design by simply adding pegboard mounting pins, it was not clear if there was a printing orientation that could be utilized to minimize potential delamination problems with the handle of the contact sensor switch and the pegboard pins when printed as an integral unit. The final choice was to break the design into two parts, a Pegboard Bracket with a Cable Management Slot (File 1001) and WYZE Contact Sensor Switch Holder (File 1003). The 1003 WYZE Contact Sensor Switch Holder also has a 'spring' to help steady and hold the part in the Pegboard Bracket. While there is a considerable amount of support required to print these objects, it is strongly recommended that the components be printed with the orientation as provided in the files to ensure maximum strength of the components. A 'cable management' slot has been incorporated in the Pegboard Bracket to restrain the Cam V2 power cable if needed. Note 1: The retaining clip or 'bump' on the Cam V2 Holder will lose some of its memory over time, but the reduced force should still be sufficient to steady the unit and offer sufficient resistance to prevent it from popping out when the switch is used. Note 2: The components have been designed for a snug fit. If the WYZE Contact Sensor Switch Holder will not slide into the Pegboard Bracket, sand the Switch Holder with a 150 to 200 grit to round the edges and reduce the width. It is not uncommon to find small variations in pegboard hole sizes. Sometimes the Pegboard Bracket will require a firm push to mount. If the components are printed with four walls, 35% infill, and in accordance with the recommended orientation, the pegs will be relatively strong and should not break. If the Pegboard Bracket cannot be inserted, carefully ream out the pegboard holes to a slightly larger size. Other WYZE pegboard accessories in this series This is one in a series of pegboard accessories. The set includes the following items that have been designed for using WYZE products with pegboards. Check with https://www.thingiverse.com/burke9119/ to see when more are added. Two Part Pegboard Mount for a WYZE CAM V2 (https://www.thingiverse.com/thing:4335549). Two Part Pegboard Mount for a WYZE Contact Sensor Switch Holder(https://www.thingiverse.com/thing:4337294) WYZE Motion Sensor Pegboard Mount (https://www.thingiverse.com/thing:4350830)