Wyze Contact Sensor Pill Bottle Housing - Sam's Club

thingiverse

I saw a post of someone who had used the original Wyze Door Contact Sensor glued to a pill bottle so there was a record of pills taken. I said I could design a housing, so here it is! This is from my small pill bottle from Sam's Club which it tapered from the bottom to top 31.5mm to 32.5mm. The closed circle is made for this exact pill bottle, but I made them with a slit so you can snap in on other pill bottles. PLA should stretch pretty wide. Each housing had a hole so you can poke the sensors back out if needed and the bottom has a hole for the Status LED. Designed to not need supports. I had a slide in from the side design, but it would have needed inner supports which cause so many issues, they fit tight so I call it good.