Wyze Cam V2 Mount for Sovol SV07/Plus

thingiverse

I wanted a camera mount that fit more or less within the printer's footprint and that could see the nozzle area. I was inspired by other camera mounts that attached themselves to the X-gantry.There are no screws required, it should fit snug on to the plastic cap for the X-axis motor. It will fit the gray base of a Wyze Cam V2 perfectly. Perhaps a little too perfectly, as it might tear off the little rubber feet on the bottom. I really wanted to make sure the camera didn't move or vibrate once mounted. I also included STLs both with cable clips (intended for a flat USB cable) and without cable clips (use zip ties or something for cable management).I tried to design this to be printed with as few supports as possible, but you will need a few to support the square mount. I used bed only tree supports and it came out just fine.Enjoy.