Wyze Cam V2 2020 Extrusion Mount

thingiverse

The main section is print in place and the hinge should move easily with little to no need to break it loose. I've also included a T nut file to make this completely a completely 3d printed mount with no need for screws, nuts, or any other hardware. The riser post is 13mm long and fits my rig nicely but you may want to tweak the z height in your slicer if you want a different camera angle. After printing, you will likely need to clean up the holes just a bit to allow for easy snapping together. The T nuts DO fit in a 2020 v slot but will be TIGHT when first twisted in. I use a pair of needle nose plyers to grab the main body and twist them in place and then to slide them in the v slot till they slide nicely. The tip of the post are slightly smaller than the base to allow for easier coupling but if there is too much resistance for your taste, you can ream the holes on the mount, just be warned that too much and the mount will become loose. To mount the camera, you'll need to unscrew the single nut/bolt at the base of the cam as the factory foot is not needed with this setup and will not allow the camera to be fully inserted.