Wyze Cam Mount

cults3d

I developed a simple mount for the Wyzecam (The original square one, not the panning camera) It's a super simple and quick printing mount that can be used to secure your camera to any flat surface; horizontal, vertical, or anywhere in between. Any material will do, although I like PETG since it's a little tougher. Resolution-wise, I'd suggest nothing higher than 0.2mm so the side clips have enough resolution to be sturdy. Updated to improve the side clips. They were fine, but not long for this world after a few uses. They would easily snap if too much pressure was applied. The new version has wider clips that hold better and are much more sturdy. I also added a thicker version with a slot down the back side to run the cable behind the camera and the mount for those who (like me) get a bit anal about cable management.