Wyze Cam Mount

thingiverse

I created a basic mount for the Wyzecam, specifically the original square one, not the panning camera. This simple and quick printing mount can be used to secure your camera to any flat surface; horizontal, vertical, or anywhere in between. Any material will do, although I prefer PETG since it's slightly tougher. Resolution-wise, I recommend nothing higher than 0.2mm so the side clips have enough resolution to be sturdy. I updated the design to improve the side clips. They were fine initially, but not long-lasting after a few uses. They would easily snap if too much pressure was applied. The new version has wider clips that hold better and are more robust. I also added a thicker version with a slot down the backside to run the cable behind the camera and the mount for those who, like me, are meticulous about cable management.