WW2 Bayonet Hanger/Holder

thingiverse

This is a design i came up with quickly, but is robust and effective. It's a storage or display hanger rack for WW2 bayonets, this design will most likely work with most other kinds of bayonets which have a frog stud on the scabbard. It fits 4x bayonets side by side, I have given them a little extra space between to accommodate models which have the barrel loop locking design. Photos are quite dark as the light level in the safe is quite low. This design is 280mm long, so if your printing on a smaller bed you may need to orient this at a 45 degree angle. I printed on an ender 5 pro, and it just fits in if you align corner to corner. This design will best print if you stand it up so the long flat section is pointing to the sky. Will require no supports that way. Roughly took 8 hours to print. The longer flat section can be drilled out for screws, or can have strong magnets recessed into it. My method of attachment was to cover the flat surface in a healthy amount of general use silicon and I just stuck it to the metal wall of the safe.