Wrist Watch Display

thingiverse

This custom-designed display is tailored specifically to fit wrist watches perfectly. Originally designed for my personal collection of NIXON timepieces, I reworked the design to make it easily 3D printable and shareable with others. The branding was removed and the display scaled down to fit within the Prusa MK3 build plate dimensions. It prints in three separate pieces that need to be glued together afterwards. To accommodate this scale, ensure watch pillows purchased online are no wider than 3 inches so they fit snugly inside the display. Alternatively, you can print the pillows using flexible filament, though I haven't attempted it yet. For more information on the original design concept, visit https://www.coroflot.com/TperroneDesign/NIXON-Watch-Display The following parts are included in this collection: Watch Display LEFT - Printing time averages around 24 hours depending on settings used. I employed a 15% infill rate. Watch Display RIGHT - Printing time averages around 24 hours depending on settings used. I employed a 15% infill rate. Watch Display INFILL - To optimize layer pattern matching with other parts, print this section vertically. Alternatively, lying it down will yield faster print times. A 30% infill rate was utilized in my setup. Watch Display Overall - This encompasses the full display if your print bed is sufficiently large. Share a picture of your creation if you decide to build one!