Wrench for LAZ16 switch nut

prusaprinters

<p>I found these neat LAZ16 switches, very similar (from the front) to the Omron A16 series that cost more than ten times as much. Obviously a knockoff and I'm sure they are not as good in the long run but they have a good positive click and look great. I want to use them in a fairly tight front panel and so made this wrench, or else it would be impossible to tighten them properly.</p><p>The castellated top of the wrench fits into the castellated nut. There is a hole for a breaker bar but don't use a bar to tighten the nuts, only if they are hard to undo!</p>