Wrapping Fix 5.78mm-Clamp for UP! Platform use with rubber band

thingiverse

This C-shape clamp is designed to prevent model "Wrapping" or "Bending" while printing. My concept involves using small round rubber bands installed with a C-shape clamp over the edge of RAFT, which usually has bending/wrapping effects, to reduce wrapping/bending effects that I tested on couple models and it works fine. The C Clamp features 2 positions to hold the rubber band - LOWER slots for ground raft layer0 which can be printed over, and UPPER slots for raft layers 1 or 2, allowing you to pause the printer (after raft layer 0/1 were printed) and install both clamps in opposite directions with rubber bands attached. This technique only works while printing with a Raft. This C-Clamp is designed for UP plus 2 printers with a platform thickness of 5.78 mm, so it can likely be used on other similar preheat platforms. Print Settings: Printer Brand: Up! Printer: Up Plus2 Rafts: Yes Supports: Doesn't Matter