Wrap Master Wall Bracket

thingiverse

I created a bracket to hold two Wrap Master Dispensers I picked up for my wife at a thrift store. These dispensers work amazingly, but they're quite large and take up valuable cabinet or counter space. To make the most of them, I decided to mount them on the wall. The bracket needed to support and store the Wrap Masters while allowing me to dispense from it while it was in place. Thankfully, these brackets exceeded my expectations and look even better than anticipated. The first version was a bit rough around the edges, with sharp corners and an off-center lower screw hole. I knew I could do better. The second version is a significant improvement, with the screw holes centered perfectly and smooth, filleted edges that give it a more polished look. I didn't use a brim on the first print, but it turned out fine despite my reservations. However, when printing the filleted version, I encountered issues without one - even on Blue Mask. Adding some final netting might help resolve this problem. Hopefully, someone else will find this project useful and benefit from my experience.