WPL Rock Crawler Additional Parts

thingiverse

These are all parts I made to make use of original WPL parts that was leftovers from when I upgraded my C24-1 to all metal. https://www.thingiverse.com/thing:4916699 Print order: 1. Axletruss x2 (These will replace the lower trusses on the rear axle they are about 8mm shorter than original, this will put the rear axle at a funny angle but that doesn't matter. What matters is the angle of the drive shaft) 2 .Servohorn extension x1 (If you like me are going to mount the servo on the "batterytray") 3. Servobracket x1 (This will need additional M3 screws and nuts) 4. Springcap x4 (These will snap on the original wpl shocks, make sure to turn the original screw hole outwards or else it will interefere with the chassis) 5. Batterytray v2 x1 (Again, this one will need M3 screws x4 but I see no need for nuts) I am yet to figure out a better solution to hold the battery and also a better angle for the front drive shaft.