WPL krAZ style wheel

cults3d

I was not satisfied with the alternatives so I went all the way and made my own. At the same time I increased the width a hair so the original tires "balloon" a tiny amount. These wheels will increase the track width a tiny bit. I made a little notch on the collar. This is so it will come out better than if you were to use supports for this part. Be careful when you snap it off and clean it slightly with an exacto knife or something similar. Including some center caps. The smaller diameter ones are for front. These might need some touch ups depending how well your printer is calibrated! Added v2 which are even wider for even more "ballooning". Note: The wheels are standard offset except v2 which has a slight negative offset. v2 works for my B36 with standard wpl metal axles.