Wowgo - Rubber Fender v1

thingiverse

Designed for use on Wowgo2's esk8 board, I'm not sure if it fits any other boards. If you found this design very helpful or wish to support me, you can buy me a cup of coffee (helps keep the brain active so I can create new stuff), then please consider using this link: https://www.buymeacoffee.com/Mb1vZjXUG. To assemble one set, you need to print 2 pieces and glue them to the board; I used some strong glue and let it sit for a while, works perfectly. I printed with NinjaFlex as my filament, but you can use any soft flex filament. The NinjaFlex I used has a shore softness/hardness of about A85. This is v1, which I currently use, but I have designed and printed a v2 version of this fender in one piece; it looks nicer than this one, but since I didn't want to print rubber with support, the v2 doesn't go as far into the face of the Wowgo board on one side. So, it's up to you which one suits your taste. This is what I've made for the Wowgo2s so far: Fender v2: https://www.thingiverse.com/thing:3592009; Handle: https://www.thingiverse.com/thing:3591850; Bushing: https://www.thingiverse.com/thing:3591964; Damper plate 6mm and 10mm: https://www.thingiverse.com/thing:3591987