Wowgo - Rubber Damper Plate

thingiverse

Designed for use on Wowgo2s esk8 board, but should fit a lot of boards since the damper is a standard item. The original rubber damper is 6mm thick, but I made a 10mm version too, which I use right now on my wowgo2s - both are available here. I used NinjaFlex as filament, but you can use any soft or hard flex filament. I think the NinjaFlex I used has a shore softness/hardness around A85. I printed these with 50% infill, but you can play around with the infill and perimeter settings to adjust it to your taste in how much dampening they should be. Designed for use on Wowgo2s esk8 board; I don't know if it fits any other boards. For one set/end, you need to print 2 pieces of this and glue them to the board - I used strong glue and had it sit for some time, works perfectly. I used NinjaFlex as filament but you can use any soft flex filament. I think that the NinjaFlex I used have a shore softness/hardness around A85. This is v1 which I use right now, but I have designed and printed a v2 of this fender that is in one piece - it looks nicer than this one, but since I didn't want to print rubber with support, the v2 on one side doesn't go as far into the face of the Wowgo board, so it's all up to you which one suits your taste. This is what I have made for the Wowgo2s so far: Fender v1: https://www.thingiverse.com/thing:3591938 Fender v2: https://www.thingiverse.com/thing:3592009 Handle: https://www.thingiverse.com/thing:3591850 Bushing: https://www.thingiverse.com/thing:3591964