Wowgo - Bushings

thingiverse

Designed for use on Wowgo2s esk8 board, but should fit a lot of boards since the bushing is standard. For one set you need to print both the "cone" and the "straight" one. I used NinjaFlex as filament but any soft or hard flex filament can be used. The NinjaFlex I used has a shore softness/hardness around A85. I printed these with 100% infill, but you can play around with the infill settings to adjust it to your taste in how dampening they should be. Designed for use on Wowgo2s esk8 board; do not know if it fits any other boards. For one set/ end you need to print two pieces of this and glue them to the board, I used strong glue and had it sit for some time, works perfectly. I used NinjaFlex as filament but any soft flex filament can be used. The NinjaFlex I used has a shore softness/hardness around A85. This is V1 which I use at the moment, but I have designed and printed a V2 of this fender that is in one piece; it looks nicer than this one. Since I did not want to print rubber with support, the V2 on one side does not go as far into the face of the Wowgo board, so it's all up to you which one suits your taste. This is what I have made for the Wowgo2s so far: Fender V1: https://www.thingiverse.com/thing:3591938 Fender V2: https://www.thingiverse.com/thing:3592009 Handle: https://www.thingiverse.com/thing:3591850 Damper plate 6mm and 10mm: https://www.thingiverse.com/thing:3591987