Worx USA Tool to EU Battery

thingiverse

I bought one of those 40v Worx battery powered pressure washers (Cheaper than UK and free shipping!) only after it arrived I realised EU batteries do not fit the tool. Therefore I turned to my 3d Printer. Assembly is straightforward, The connectors clip into the slots I only wired up the + and - terminals and it works fine. The clip needs 2 bits of unseal on the underside to allow it to be pressed down and is trapped in place on assembly BOM (to make 1-off) 2 x M3x18 Cap Head screws 2 x M3 Square nuts 2 x TE Connectivity 293041-1 2 x TE Connectivity 964202-1 1.5mm2 wire (I used house wire) 25x4mm Foam Seal self adhesive. I requested a sample of the connectors from TE Connectivity and they sent me enough to do this little project or try eBay. Credit to the following for the battery, some of the dimensions needed tweaking. https://grabcad.com/library/worx-20v-battery-model-1 This was remixed from https://www.thingiverse.com/thing:4602083 DISCLAIMER - Use at your own risk etc.