Worx Landroid Fubben wheel

thingiverse

A wheel that allow mounting the "Fubben" spiked steel wheel side without modifying the chassis of your Landroid. Fits M-Series 2019 at least (WR141E pictured). Slightly larger diameter wheel (195 mm) to match the outer diameter of the steel wheel side. Slightly smaller protrudes on the wheel to fit most printers and allow for the spikes to work. Use 3-6 40 mm M5 machine screws to secure the steel wheel side. Print with preferred settings and material. PETG, ASA or ABS would be preferable but scale accordingly if using ABS. With PETG no scaling is required. I used 0.3 mm layer height, 4 perimeters, 3 bottom and 4 top layers with 10% infill. One wheel weighs about 260 grams with these settings. Add support at the center shaft and below each captive nut.