Workmate feet big and small

prusaprinters

<p>Large lower foot and smaller triangular foot for Black and Decker Workmate WM5XX. These fit well and have been on mine for some time now. I printed these in Rigid Ink TPU with the speed slowed to about 20mm/sec. I still get a bit of stringing on the inside but the outside finish is good and the strings can be just pulled or cut off.</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>Prusa Mk2</p></div><strong>Rafts:</strong></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div><strong>Resolution:</strong></p> <p>.2mm</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>100%</p></div></p> <p><strong>Notes:</strong></p> <p>Works best with the speed slowed down to about half normal as this reduces the stringing. I use either 100% fill or many perimeters to get a solid bottom casing as they get a lot of wear. Print with the bottom of the foot to the bed and you will not need supports</p> </p></p></p> Category: DIY