Working Ultimatrix chest piece

pinshape

The following symbol will be easy to recognize if you have seen this series. If you rotate the symbol, you can easily switch between normal and ultimate Omnitrix. This form of Omnitrix appears in the game: Ben 10 Ultimate Alien ™ Cosmic Destruction, and it's also featured in other games. Ben 10 is an animated series produced in the United States by "Man of Action" and Cartoon Network Studios. The pilot episode was released on December 27, 2005, its second episode aired on January 13, 2006, and the last episode was broadcast on April 15, 2008. The developed, improved, and modified form of the Omnitrix is the new Ultimatrix system. This system has all the powers and capabilities of the Omnitrix, as well as the power to become the aliens of Ben in their new versions. With the ability to bring them to an evolved version, making them much stronger with better and more powerful capabilities. To activate this change, Ben presses the Ultimatrix / Super Omnitrix command prompt, taking four points and transforming the alien into its supreme form. To assemble it, you will need 4 small springs, which can be made from spent bolts. Remove a piece that is not needed from each bolt to create the spring. The pieces can be painted before or after assembling them. In my case, I painted them before assembly. To do this, I sanded all the pieces after printing them, applied two layers of primer, and then sanded them again. Finally, I painted them using acrylic paints. Assembly instructions: 1. Print all the pieces, making sure to print each point four times. 2. Place the pieces (points) in the base, inserting the springs inside them. This is easier if the base is flat and on this we place the springs and then the pieces (points). Before moving on to the next step, I would recommend sanding, printing, and painting the pieces (points), as it will be more difficult to access them later. 3. Once the previous step is complete, you can attach the upper part of the base to the lower one. Make sure the mechanism works before attaching the pieces. If it's hard to remove the pieces, it may be because the springs have too much force. 4. Finally, all that remains is to screw the part with the symbol until the pieces (points) start to come out. Printer settings: Printer speed: 100mm/s Extruder temperature: 200°C Bed temperature: 40°C Infill: 10% honeycomb Printed with PLA.