Worker Dominator Solenoid and Sensor Mounting Hardware

thingiverse

These are some of the components I am building into my triple brushless Worker Dominator. Warning: This is a significant upgrade to the Worker Dominator - you can't go back once started. If you choose to use the triple brushless setup, please be aware that serious injury may occur to the user and anyone nearby. **Dominator Chrony LED Holder** Print with the round side facing down. Supports are optional, but feel free to add them if desired. Infill is not critical since it's not a structural component. Any Nerf blaster can accept this on the standard barrel. Use the hole guide to ensure your barrel holes are correctly aligned. **Dominator Console Parts** Not a structural part - print as you prefer. This mounts 3 buttons, an OLED screen, and a select fire switch to the left side of the blaster. **Dominator Sensor Parts** Not a structural component. These will mount a selection of IR sensors into various positions on the dominator. **Dominator Solenoid Parts** Structural. Print with full infill. The nub will glue onto the brass pusher end on the solenoid. The only supported solenoid is a 35mm eBay/ AliExpress unit. **AFG** This is a remix of the Caliburn AFG, modified to fit the length of the dominator. **Electronics Cover** This is an extended battery bay cover allowing for various electronics. There's a cut-out for a USB-B port. You could potentially use it as a battery extender. Two options are available: one plain and another with a Hello Kitty design. **Installation** Keep in mind that this is still early days, and I haven't fully completed the blaster yet. You can follow my Swordfish Solenoid Install guide to get an idea of what's involved, but you're largely on your own at this point. **License** All these components are my original designs, so no commercial use is permitted. The AFG, however, follows the Caliburn license.