Workbench Dremel Bit Storage

thingiverse

This is a remix of Dremel Bit Storage by MrRobot6502, thing 4166355. When I tried to print the original on the Prusa MK3S, it curled so badly that it lifted the magnetic sheet off the bed. But that problem brought to light that there was a lot of wasted space below the upper bit storage. So I ended up breaking it down the into six pieces and added a couple of drawers in the back to use the space a bit more efficiently. I also, as an afterthought printed 4 of the double wrench cradles to CA glue on the back. I have several older, double ended wrenches that have different sizes on each end and they didn't fit the slots in the original design. Could have put them in the drawers but, what the heck. This way gives easier access. For the knobs, I used the knob out of the Sanding Tool by perinski, thing 3159240 which I was in the process of printing at the same time. Note that I didn't put holes in the drawers for the 3mm screws to mount this but, a drill took care of that problem. Obviously, since it's now in pieces it has to be assembled. I used Loctite gel superglue for the six main components and the wrench cradles. Files: dremel L - Left wall dremel R - Right wall dremel 1 - Front (in front of #2 & L & R) dremel 2 - Behind #1 bottom, open to back dremel 3 - Fits above #2, open to back dremel 4 - Fits above #3, rearmost drawer 1 - Bottom drawer, goes in back drawer 2 - Top drawer, goes in back