(work in progress) Simpsons TV for pi4 + Hyperpixel

cults3d

First version of the tv, technically works but not great. I will try to get these updated if there is any interest. Check dimensions before printing. Print at your own risk. Buttons and VCR still need to be scaled before slicing. Power needs to run through bottom panel of the TV Body if you're using the usb-c port of the pi. That hole doesn't exist in this model so plan to drill a hole. I soldered the audio amp to a usb audio device to get slightly louder volume (it's still pretty quiet). Power button can be attached to the GPIO pins like the original guide describes, just insert them into the hyperpixel's adapter, no soldering needed. The holes for the power/volume knobs are scaled up, so if you use the smaller hardware, you'll need a lot of hot glue to support everything.