Woozi Folding stock

thingiverse

I really loved the addition of a stock attachment point, but I was craving a folding stock that was sleek and resembled an actual micro UZI stock. So, I found a 1:1 mini uzi replica on Thingiverse and tweaked it extensively, creating a mounting plate in the process. Prints are generally oriented for printing, so use supports where necessary. A bit of brim is recommended when printing the arm. You'll need at least a build height of 234mm to print the arm in one piece. I've found that driving a screw through the hinge plate into the hinge pin from below enhances stability. The hinge contact surfaces require some sanding to fit properly, and the ends of the arm must be sanded to fit in the butt plate holes. It will be snug, but no glue is required. The hinge needs to be printed with high infill. I recommend 100% infill. An issue was discovered in slicing the butt plate on Cura 4.1, which isn't present in earlier versions. If using 4.1, check the keep disconnected faces setting in mesh fixes. The hingplate slingpoint has been temporarily removed until some issues with it are resolved.