Wooden Table Lamp

prusaprinters

<p>The wooden lamp is available with feet or clamp to build in 24.5 mm or 25 mm diameter wood rods.</p> <p>If you need to separate the parts my suggestion would be to use Prusaslicer. Import, split into objects, then you can delete rest of the parts and export to a new stl if you would like to use another slicer.</p> <p>In my case the oak is 24.5 mm and birch is 25 mm. I recommend that you test print rings (split a joint) in different scales and test fit them before printing the whole plate. Please note that the standard M6 screws may not fit if the parts are scaled to much. Use support.</p> <p>Hardware necessary:<br/> 24.5 or 25 mm dowel wood<br/> 2 m textile lamp cord 6 mm diameter</p> <p>Foot version:<br/> 4x 250 mm rod<br/> 2x M6 Wingnut<br/> 2x M6 Washer<br/> 1x M6 carriage bolt 80 mm<br/> 1x M6 carriage bolt 110 mm</p> <p>Clamp version:<br/> 2x 250 mm rod<br/> 3x M6 Wingnut<br/> 3x M6 Washer<br/> 2x M6 carriage bolt 80 mm<br/> 1x M6 L-bolt 20x80 mm (this is not a standard size)</p> <p>Please contact me on contact@fransjohansson.se if you would like to buy hardware kit.</p> <p>Assembly steps:</p> <ol> <li>Glue rods in the joints and align properly</li> <li>Drill out the holes 6 mm to make sure the bolt go through</li> <li>Assemble bolts, washers and wingnuts.</li> <li>Attach lamp cord</li> </ol> <h3>Print instructions</h3><p>I use the following print settings:<br/> Layer height: 0.3<br/> Infill: 20%<br/> Supports: Yes</p>