Wooden Table Lamp

thingiverse

Hi Friends, Here is a dowel wood-based table lamp I designed. The goal was to create something which is very simple and has only wood and printed parts. In other words, something which is ready to go right after printing, with minimal effort to assemble and without metal screws. I have used dowel wood of 1-inch diameter. There are 5 types of STLs. 1) The base that touches the tabletop at the very bottom 2) The second level base where the switch is attached 3) The dome at the top in which the bulb is placed 4) The rings which are used to tighten different parts together 5) The clamps which are used to keep the wire tight along the dowel Few tips: 1) Drill a hole on the dowel at the top with an angle (~45 degrees) in order to house the 5V wire connector. 2) Just print a single ring and make sure you can insert it on the dowel. If everything is good, you should be able to insert the ring and remove it with just enough tightness. This way you can make sure that the rest of the print will work too. 3) You may stain the dowel in case you prefer it. Here is an example of a dowel that I used: https://www.homedepot.com/p/6416U-1-in-x-1-in-x-48-in-Pine-Round-Dowel-10001808/203334068 I have used this LED bulb: https://www.toolmoon.com/store/p36/tBulb2_S_%28%E2%80%8BStraight%29.html Please let me know if you have any questions.