Wood Clamp Quick Adjust 3/8 Size

thingiverse

This is a quick adjust clamp that utilizes a washer positioned at an angle to provide the quick adjustment. To assemble this clamp, you will need: * A 3/8 threaded rod of any length * Three 3/8 bolts * One 3/8 washer with an outside diameter of approximately one inch * Two 5/16 washers that fit between the handle and the stationary clamp The 3/8 washer is installed in the sliding clamp, while the two 5/16 washers are placed between the handle and the stationary clamp. Next, two nuts are secured to the end of the threaded rod, with a hammer used to damage the threads so that the nuts remain in place. With the handle pointing upwards, the threaded rod with the nuts is then placed on top and struck with a hammer to drive the nuts and threaded rod into the handle. The nuts and threaded rod stay securely in place due to two small tabs on the handle. Finally, a third nut is added to the stationary clamp to prevent it from moving.