Wood Clamp Quick Adjust 3/8 Size

prusaprinters

<p>This is a quick adjust clamp. It uses a washer on an angle to provide the quick adjust.</p> <p>You will require</p> <p>3/8 threaded rod any length<br/> 3 - 3/8 bolts<br/> 1 - 3/8 washer (outside diameter is about 1 inch)<br/> 2 - 5/16 washer (goes on the handle)</p> <p>The 3/8 washer goes in the sliding clamp. The two 5/16 washers go between the handle and the stationary clamp. 2 nuts go on the end of the threaded rod. I used a hammer to damage the threads so that the nuts will stay in place. I then put the handle pointing up and put the threaded rod with the nuts on top and hit the rod with a hammer to drive the nuts and threaded rod into the handle. The nuts and threaded rod stay in place because of the 2 small tabs on the handle. The 3rd nut goes on top of the stationary clamp just to stop it from moving.</p> <h3>Print instructions</h3><p>Category: 3D Printing</p>