Wolf Head Keychain (Pencil Topper)

thingiverse

In addition to remixing a full-sized wolf head for my son's Cub group, I created this smaller version myself. It is designed to be printed in one piece, angled facing upwards at 45 degrees, so the chin prints correctly. (The STL file should load into Cura already at the proper angle). This print requires supports everywhere, and I used tree supports. I also recommend adding a brim. There's a key ring loop at the back and a hole that can be used as a pencil topper. Note: I tried out a few pencils and found that some are slightly bigger or smaller than others. I designed it to fit the pencils I had bought for this purpose. There will also be variations depending on your printer setup, so you can use Cura's "Horizontal Expansion" feature to compensate for minor differences. If the hole is too big or loose, try increasing your Horizontal Expansion (for example, by 0.05 mm). On the other hand, if the hole is too small and doesn't fit onto the pencil, decrease the Expansion (for example, by -0.05 mm). You may need to test it out a bit. Enjoy this smaller wolf head, and if you like it, please post any makes or creations you come up with. Large Wolf Head Here: https://www.thingiverse.com/thing:3692238