WLtoys 144001/124019 shock screw braces

prusaprinters

<p>Shock mounting screw brace with shock guards. This design ties into the alternative shock mounting holes for more support. It is designed to be tapped to M3x0.5mm so the screws fasten directly to it, it does not use nuts. Reuses stock spacers. I had to drill out the lower 2 holes of the shock tower to fit an M3 screw as the laser cutting left a little burr or was slightly undersized, you may or may not have to on your car. You will need 2 additional M3 screws between 8 and 20mm. If you do not have an M3 tap you can heat a screw up gently with a lighter or soldering iron and thread it in. You may also just be able to force it in and have it self tap, or use a sheet metal type screw. Any non flexible filament is fine, PETG preferred.</p><h3>Print Settings</h3><p><strong>Printer:</strong></p><p>Flying Bear P902</p><p><strong>Rafts:&nbsp;</strong></p><p>No</p><p><strong>Supports:</strong></p><p>No</p><p><strong>Resolution:&nbsp;</strong></p><p>0.2mm</p><p><strong>Infill:</strong></p><p>25%</p><p><strong>Filament:</strong></p><p><a href="http://www.amazon.com/s?url=search-alias&amp;field-keywords=Overture+ABS">Overture ABS&nbsp;</a></p><p>Black</p><p><br>&nbsp;</p><p><strong>Notes:</strong></p><p>&nbsp;</p><p>No rafts, or supports needed, designed to be printed at 0.2, but you can do 0.1 if you like.</p><p>&nbsp;</p><p>&nbsp;</p><p>Category: R/C Vehicles</p>