Wise Glide: Orbital Rig for Wyze Cam Pan

thingiverse

I needed to see beyond my 3D printer while I was away from the office. Behold! The Wise Glide: Orbital Rig for Wyze Cam Pan. Below are all the pieces of hardware required to get this project underway. You can attempt to print your own wheels, but I opted not to. The feet for the rail feature a friction fit design and may require hammers or glue depending on your printer's capabilities. They are substantial due to the weight they must support. A decent infill is highly recommended. The gear will fit on a Prusa bed by angling it from the bottom corner to the top opposite corner. Don't forget to print two feet! I am still refining this design and consider myself far from an expert. This post marks my first contribution to the community, but if you are a seasoned pro who can improve upon this concept, I would be thrilled to see your creation! Be sure to check your tolerances as the feet may require scaling up to fit snugly into the posts. I added a bearing buffer ring to the center wheel to tighten up the mechanics. For reference, the following components were used: * Wyze Cam Pan: https://www.wyze.com/wyze-cam-pan/ * Right-Angle Micro-USB cable: Please note that you will need to hot glue the ribbon onto the moving part of the plug. Mine fell out after a few hours of use: https://amzn.to/2SGguOO * Bearings 5mm inner diameter 11mm outer diameter: https://amzn.to/2K3eBb1