Wireless SNES Dual Turbo Controller Battery Lid

thingiverse

I created this lid for a friend who lost his, and it's a simple reproduction that was done in about an hour in Solid Edge using only a calliper for measurements. It's not a perfect reproduction, you'll need to sand it after print to make it fit perfectly, but it gets the job done. I included two .idea files to use in IdeaMaker so that it's already placed with support material at the correct key places. I printed mine upright because it gives the most strength and accuracy across the X and Y axis for this particular part, which was important for the tabs and little locking mechanism. However, it's also possible to print flat with proper support orientation, but the accuracy of some areas will likely suffer. I printed it in PLA, but any material should work fine since it's not a piece that requires very high strength. The locking mechanism part is not perfect; it could be angled much better and the curve should be made thinner to allow for a more flexible piece. However, I only needed one of them, so I didn't feel the need to tweak it and print it again since the first one worked just fine after some sanding. Feel free to remix it to make it perfect.