Wireless charging phone spacer for 2020 Tesla Model Y

prusaprinters

<p>Remix of chilman408's Model 3 dock spacer with a few modifications to better fit the 2020 Model Y, and to be easier to print. May also work with newer Model Ys.</p> <p>This allows the Model Y's wireless charging pad to work with iPhone 12 Pro Max in both the Apple silicone and leather cases (and probably other similar cases as well). Without it the charging is either spotty or non-functional. The new Pros are thicker than previous phones, and the led to a poor fit on the pad that left the charging coils misaligned. This provides an additional 6mm of width, way more than necessary, and should work with a variety of thicker phone/case combinations.</p> <p>Free to use and modify for non-commercial use.</p> <p>Update 12/24/20: Added v12, which contains a few improvements:</p> <ul> <li>Fixes a 1mm faceplate offset that was present on the original model. Now the stock Tesla faceplate fits flush on the spacer</li> <li>Adds a small wall around the top of the spacer so that it fits flush against the faceplate. No more room for dust to drop in.</li> <li>Moves the ledge the phone rests on down by 3.25mm. This is about the maximum offset supported by the design while still fitting the stock faceplate. The phone would disconnect over large bumps, which this seems to resolve by better aligning the charging coils.</li> </ul> <p>Recommend PETG given interior vehicle temperatures. PLA will distort over time, especially in warm climates. See the print settings below. They're important.</p> Category: Automotive