WIPEINATOR-11000 Handi Wipe Holder

prusaprinters

<p>The WIPENATOR-11000 is a handy overhead holder for your Handi Wipes or other cleaning towels. Easy reach to clean your 3D print bed or any other area that can get messy.</p> <p>Features:</p> <ul> <li>Saves space on counters or inside draws and takes advantage of unused space.</li> <li>Holes on the bottom give visual indicator that the dispenser is not empty</li> <li>Sturdy construction</li> <li>approx 11 CM of towels can be stacked.</li> <li>Print it with the PLA to match your cabinets.</li> <li>4 screw mounts (I used 8x3/4"). Double stick tape could also be used.</li> <li>Fully assembled dimensions: L: 30mm: W: 18mm H: 12mm</li> <li>Inside dimensions (L: 28mm: W: 16mm H: 11mm) - Towel area<h3>Print Settings</h3> </li> </ul> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>I3 MK3S</p></div><strong>Rafts:</strong></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div><strong>Resolution:</strong></p> <p>200</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>20</p></div><br/> <strong>Filament:</strong><br/> Overture PLA <br/> <p class="detail-setting notes"><strong>Notes: </strong> </p><div><p>You will need a print bed capable of a 24x18 print to print the bottom.</p> Printing and Assembly Instructions</div></p> <ul> <li>Print a single bottom piece. (I did not need supports on my MK3S. You may for the slots.)</li> <li>Print sides 2x. Lay them down so the logo is facing up. You should not need any supports in this position.</li> <li>Test fit. Sometimes your printer will make the slots on the side a bit messy. Clean them out with a small screw driver or thin file. </li> <li>File and sand to taste before assembly being careful not to over do it on the front facing parts.</li> <li>You can use the circles on the bottom to put your fingers through to get extra leverage for a tight fit.</li> <li>Once it dry fits nice, and a thin stream of super glue in the slots and quickly reassemble. Hold for 10-15 seconds</li> <li><p>Give any last minute sanding Mounting</p> </li> <li><p>Use some tape to hold position your holder where you want it. Measure as you see fit.</p> </li> <li>Mark the holes with a pencil</li> <li>Remove the unit. </li> <li>Drill a few small pilot holes. Careful not to go all the way through the cabinet.</li> <li>Screw in place by hand with a screw driver.</li> </ul> </p></p></p> Category: Organization