Winwing finger lift V2 with detents for afterburner

thingiverse

Here is the link to the model for folks to tinker and recreate as they see fit. No permission is required from me: https://www.tinkercad.com/things/4b1VChWB72a-wingwing-fingerlift-v2/edit?returnTo=%2Fdashboard%3Ftype%3Dtinkercad%26collection%3Ddesigns&sharecode=TtVGcJfOPJjK3ILAzL1d4BU71OcYp0uYh2pDOX2WucM Upon request I have made an updated version of my Winwing finger lift (https://www.thingiverse.com/thing:5986326/files) to include an afterburner detent. So, I had to revise a lot of this and think this is much better than the first version. This one has a nice catch for idle. Then at the end of the base, a smooth roll over that magically adds some resistance that you can feel. the finger lifts roll back without issues.However, unlike my first version where everything listed is all you needed, this one requires a few extras. First, you will need to bolt the arm of the "catch" to the throttle handle. Second, this one needs springs or rubber bands. I found a few hair bands in the car - amongst the GF's makeup, overnight bag, basically, and extension to the bathroom in the footwells - and tied them to the throttle. These keep the catch close to the base.I prototyped at an infill of 20%, seems fine for now - but hey, if it breaks just print again only takes 40 mins max.Layer height was 0.32 with a 4 mm nozzy-noz.Feedback is most welcome. And if anyone wants to update this just go right ahead, you have my blessings.