Wing Spar Bolt Cover for Piper PA-28 / PA-32 / PA-34 / PA-44

thingiverse

A replacement part for GF63942-01 or GF63942-00 (if you mirror the STL). Like a doofus, I rolled over my previous part with a crawler during an annual. Instead of spending $100 on a piece of plastic, I printed this. I orientated it on it's side to print and enabled supports. The front lip is 1/16" as the original, but all other edges are 1/8" to make it a little more ridged. Once printed, you'll need to drill holes to align with where your existing holes were drilled. I accomplished this by putting painters tape on the plane, aligning the printed cover to the spot, and tracing everything onto the tape, poking out the holes, and then drilling those holes in the plastic. ****I am not responsible or liable for an damage done to aircraft because of different scaling. Use at your own discretion.