Wing mounted adjustable motor mount v2

thingiverse

Hi, Take a look at my other designs here: https://www.thingiverse.com/mg_evolution/designs This is my v2 wing-mounted motor, which allows the motor to point upwards on a flat wing. I made this adjustable by changing the front cone section using 2 x 3mm screws. There are 0, 3, 5, and 7-degree mount options. The front cone is slightly longer than the original design and has a locating tag for added twisting strength. The files should be ready to print flat on the bed with layer height set to 0.2 mm and 100% infill. **Note:** I have not tested this design yet as of January 1, 2019. The original design is based on the FT Sparrow (universal) dual motor wing mount: https://www.thingiverse.com/thing:2934096 I created this for the FliteTest Sparrow, but it can be adapted to fit any wing with a flat bottom profile. This design should accommodate a 1104 motor as is. For reference, I used the following dimensions: * 2mm thread with 9mm between thread centers (for 1104 motors) * 2mm thread with 12mm between thread centers (for 1806 motors) The motors sit forward of the center of gravity (COG), which I estimate to be 1.75 inches back from the wing front. I designed the motor mounts to be hot-glued in using a slot that measures 5mm x 15mm. The cables are then run through the wing body to the center, where they exit at the rear of the servos. Feel free to ask questions or suggest changes/ideas.