wine glass rack

thingiverse

I designed it to fit snugly with 1/4 smooth or threaded rods, but in reality, I had to enlarge the holes using a drill. The best part is that you can cut the rod to any length you need. Possibly, 6mm rods will also fit well, even better than they are 0.35mm smaller! It was intended to be secured with two screws, but only one of them is sturdy enough for me. I used #6 5/8 screws that can be found in most hardware stores. This design can fit under a bar or under kitchen cabinets. You will need to adjust the width between them using your wine glass; it should be as tight as possible to allow the glass foot to slide between the two printed parts. I hope you'll take some pictures and share them on "make".