Wind Twist V7 Sun and Moon

thingiverse

This wind-twisted contraption is a real treat to observe. It's been printed in two segments, each featuring internal supports and an overhang of at least 35 degrees, ensuring that the supports only appear on the cut-out areas rather than along the sides. When removing these supports, be patient – some of them can be quite fragile and prone to breaking. I've opted for a layer height of 0.2mm, which tends to produce better results than the standard 0.3mm setting. For outdoor use, I highly recommend utilizing PETG filament due to its superior durability in harsh UV conditions. While PLA might still work, it's not the most ideal choice given the intense sunlight exposure.