Wind guard for Samsung HMX-qf30

prusaprinters

<p>This is a wind guard for the Samsung HMX-qf30 video camera. Just cut out a piece of kitchen sponge ca. 37mm x 12mm x 12mm (1,45in x 0,5in x 0,5in). it should stick out a bit to seal up nicely.<br>I've added a small flat surface on the bottom to keep it from toppling over.</p><h3>Print Settings</h3><p>&nbsp;</p><p><strong>Supports:&nbsp;</strong></p><p>Yes</p><p>&nbsp;</p><p><strong>Resolution:</strong></p><p>It looks fine in 0.2</p><p>&nbsp;</p><p><strong>Infill:&nbsp;</strong></p><p>100%</p><p>&nbsp;</p><p><strong>Notes:</strong></p><p>It is important that support is set to everywhere.</p><p>i printed in PLA and it's really strong.</p><p>&nbsp;</p><h3>Post-Printing</h3><p>the support is easily removed after printing. then just cut out a 37mm x 12mm x 12mm (1,45in x 0,5in x 0,5in) piece of kitchen sponge, and place it in the cage. if the wind is still disturbing try with a larger piece of sponge to create a tight seal.</p><p>I don't know if the design fits other camcorders but if it has the same styled mic and the dimensions shown in the picture above, give it a try.</p>