wii controller-memory cover

thingiverse

This thing was created with Tinkercad, edit it online at https://www.tinkercad.com/things/7eKViH8MW06. It was designed out of necessity based on Mburr's cover. Be cautious when removing the support: it is a 0.40 separation above and below. The model has integrated support, so no additional support is required in the slicer. Here's a tip: push the nodge between two fingers, then remove the support with slim pliers from left to right while pulling gently. This technique worked perfectly for me. Remember that it's a tight fit in the Wii, but I managed to push it in using some degree of push manipulation. If you like this model and plan to make one, please post a "make" on https://www.thingiverse.com/thing:3504969/make. Your support means a lot to me during modeling; consider donating with a nice cup of coffee at https://www.paypal.me/Vanvoorn.