Wii Balance Board Wall Mount

thingiverse

Wii Balance Board Wall Mounting Bracket. I created this wall bracket after I Fixed my TV and Media system to the wall. Subsequently I had no where to hide the Wii Balance Board any more so I made this. It is very strong as I have children who are not that delicate with things so it had to be robust in that sense. the balance board is quite heavy in itself so i added some cut outs to the main body to make sure it would be ridged. the front tabs allow the board to flip forwards enough to allow for easy removal rather than just a straight pull up to remove it.(this bit helps with smaller people) I printed it with 40% infill to keep it super strong and long lasting, down side is that it will take about 10 hours to print both brackets. both will fit on an ender 3 bed together. layer height was 0.3mm. it will require support for the vertical cut outs and the wall mounting holes. (infill can be reduced if you think you can get away with it, it is quite a chunky bracket so should be quite strong either way)