Wiggle Wart Replica Fishing Lure

cults3d

This is a replica of a classic Wiggle Wart crankbait. The lure is printed in two halves and then glued together. This is not an exact copy of a wiggle wart (only a close replica) so don't expect the same exact action as a store bought one. (even the store bought ones these days are not the same as the originals) The action of the normal sized version of this printed lure can act a little erratic and the Supersized version is very buoyant (@25% infill) but works great on a steady retrieve. Playing around with different infills may change the buoyancy characteristics of the lures. (you'll have to experiment as I haven't done any further testing other than the setting I initially used. See https://www.theneverendingprojectslist.com/fishingprojects/wigglewart/ for more info. Hardware Required to Assemble (for regular size lure) (3) Alignment Pins (made from 1.75mm filament) (3) #6 Figure 8 Hook Hangers (Available from https://lurecomponents.worthco.com) (2) 7/32″ chrome balls I used #6 Treble Hooks w/ #3 Split Rings (I do not remember the ball size I use on the supersized one but the hole chamber sizes are .42 and .36") Tools Required to Assemble Razor Blade/Knife Drill and Bits (1.8mm or a 5/32") Lighter CA Glue (superglue) CA Accelerator Sand Paper Paint Epoxy (to seal everything up) If there are any problems with the STL's or you have questions please let me know. NOTICE - My files and designs are all Copyrighted © and are exclusively for private and personal use. Even if you purchased these files that Copyright means you are NOT allowed to sell the model or any derivative of the model for economic or financial gain. For example, you cannot sell the digital model, a derivative or adaptation of that model, nor can you sell prints of the model. I do however grant permission for persons who purchase any soft bait molds to sell the rubber soft baits you make with one of my printed soft bait molds.... but again you CAN NOT sell the actual models of the baits.