Wifi pineapple mk7 case

cults3d

In my version of the wifi pineapple MK7 case, long story short I realised that it can get warm quite fast so I added more holes to vent the air and let the warm air out. Plus antennas on the side so as not to be obstructive in packing. As in the original case, another problem I had was the layout of antennas would cause it to be iffy to put it in bags, without additional security as an antenna on each side was a bit annoying and often antennas would pop out of joints. SO here is my fix to that too. I also added the little 20x10x3mm window for small lithophanes or plastic cover or picture to add some of the originality and ability to customise. of course, I recommend making the little window for the window hole out of white filaments or clear ones, for printing lithophanes I recommend Prusa slicer but google if in doubt. I'll assume you probably know how to slice 3D models, So I won't explain, like I said before if in doubt google is your friend. The only things required are the screws and antenna nuts found in the original case, Otherwise, just pop the original wifi pineapple mk7 PCP into the case and there. Hope you enjoy this case as much as I enjoyed designing it while procrastinating from upcoming deadlines. Also got inspired by other wifi pineapple cases, which I strongly suggest getting as they support actual creators and their business partners.