WiFi Mount for TP-Link TL-ANT2409A/B

thingiverse

Here are the directions to assemble and mount your new Wi-Fi antenna from TP-Link, model TL-ANT2409A or B. 1. Carefully unpack all the included accessories: antenna assembly unit, quick guide, magnetic base and screw with adhesive strip. 2. Remove any plastic covering or stickers still stuck to the metal tip of the magnetic base. 3. Align and attach the screw through a hole in the antenna's underside, and then firmly push it into the center hole in the base for stability. 4. Twist the antenna assembly clockwise into its mounting fixture, about 10 full turns. 5. Once you're ready to put up your TP-Link Wi-Fi range extender antenna outside for optimal coverage, remove it carefully from the protective packaging by sliding the two side flaps outward towards the edge of the box and lift out the main section and accessories as needed. 6. Locate the desired place where the antenna should be fixed to maximize signal reception; a corner of your home works well but you can choose anywhere depending on available room. 7. If required, stick the provided strip adhesive with mounting fixture by holding the small plate with one hand against desired wall or roof area and peel away protective paper from backside - ensuring it securely stays in place after pressed onto surface - 8. Position magnetic base into threaded mounting post making sure you hear audible "click" signifying correct position achieved successfully now attach provided metal rod onto center stud by tightening up slightly till snug fitting condition reached - avoid over tightening though! 9. Once firmly secured on desired location hold onto the TP-Link range extender close and securely pull up towards base slowly so antenna's screw tightens correctly ensuring not to strip or bend it 10. Now let us review quickly everything looks perfectly fine as per previous instructions completed properly right