Wide Y Axis Mount for Camera Arm

thingiverse

I'd tried a bunch of different mounts but the arms kept giving way due to the length. A different Y axis mount https://www.thingiverse.com/thing:3351438 didn't work as it interfered with the Y axis pulley on my neptune 2. I redesigned it to leave a gap around where the pulley was by widening the support that goes over the end piece. Version v1 was still slightly rubbing but may work for some printers. Version V2 removes the horizontal bar along the top of the mount so it might be a little weaker in the long run but no longer interferes with the pulley. I also kept the small holes on the bottom which I believe are for using a zip tie to secure the mount to the printer but so far I haven't seen a need to use them.