Wicked-1X mini quad frame - true x 200mm

thingiverse

This is a fun little project that I have created so I don't lose it every time I break something on a carbon frame. This "Wicked-1X" mini quad frame is created to give me (or you) more flexibility in design and parts availability in my builds. I have mainly concentrated on ease of access to components and replacement of parts. Parts List Arms The arms can easily be replaced by removing only one screw, which also connects the standoffs to the frame. Bottom plate The bottom plate holds everything together. The arms are friction fitted by sliding them into their designated place. Top plate & Holder plate The holder plate simply covers the bottom plate. The top plate holds the standoff together and has a small hole at the back to attach the antenna. I have yet to design a GoPro case. Other than the prints above, you will also need: - 9 - 10-12mm M3 screws (4 for arms, 4 for stack, 1 for camera mount) - 4 - aluminum standoffs for your stack - make sure it fits your stack - 4 - 5-6mm M3 screws for the top plate - Zip ties Assembly Print out the bottom plate. Then print out the arms - at this point, make sure that the arms slide into the bottom plate nice and snug. Next up, you need to print out the bottom plate holder. Now you can assemble the bottom half. Go ahead and sandwich it all together - slide in the arms on the bottom plate and attach the bottom plate holder. This is where I recommend adding the internal electronics. Once that's done, attach the top plate and antenna. INFO If your main battery cable comes out at the back, you have two holes for a zip tie to hold the cable to the frame located on the bottom plate - this is so when you crash, you don't break off your VBAT pads. Fusion 360 link - http://a360.co/2Bxtfkp I would love your feedback and remixes. They are very welcome.