Whoop gates

thingiverse

This is a very simple printed tiny whoop size quadcopter gate. You only have to print two parts and assemble the gate and its support using any less flexible tube with an inner diameter of 8 mm. I used the black tube commonly found in automated gardening systems. For the gate, you will need 1.20 meters of tube. After heating one end, push it into the connector for a tight fit. For the support of the gate, use four pieces of 30 mm tube and heat their ends to make them soft. Then, push them into the cross base. If your tubes are curved, use a hair dryer to straighten them out.